Inflation Blower Kit

These motors and supplies will allow you to inflate the space between two layers of polyfilm. Part of the popularity of polyfilm greenhouses is due to the fact that they are usually considered temporary structures. Thus, less hassle with permitting, etc. But, with a single layer polyfilm greenhouse, you may find that there is not enough insulation and that the heating costs are too high. A double layer of inflated polyfilm will save you up to 40% in heating costs! This is a very economical way of raising the insulation factor for a film greenhouse, while not interfering with the light transmission. These units come either with a 60 or 148 CFM motors. The 60 cfm motors are designed to be used for smaller hothouses up to 2200 square feet. The larger motors are for greenhouses over 60′ in length. Connectors for inserting and attaching to the poly, metal blower mounting brackets,  4-foot flexible ducts and installation instructions are included with the units. The single stack inflation kit is for inflating one wall/section of the poly greenhouse. The double inflation unit can be used to inflate two different walls/sections with one motor. The jumper kit is used to pass inflation air between two adjacent sections of double-wall greenhouse film. The jumper kit can be installed to “jump over” obstructions in the plastic/air flow such as wall joints, corners, and headers between walls and ceiling. For certain greenhouses, installing jumper kits may eliminate the need to install multiple inflation blowers to fully inflate all sections of the structure. Click here to view our UV resistant greenhouse plastic sheeting and additional accessories.